EXOCARB ® DG Long Length of Cut DG Coated 4-Fluted End Mills for Graphite
Contouring List 7470: DG-CR-EML
Graphite
Work Material
Roughing
Finishing
Cutting Speed
246 SFM
246 SFM
Aa = 1D Ar = 0.1D
Aa = 1D Ar = 0.05D
Depth of Cut
Mill Dia.
Speed RPM 20,000 15,000 10,000 10,000 7,520 7,520
Feed in/min
Speed RPM 20,000 15,000 10,000 10,000 7,520 7,520
Feed in/min
Inch 3/64 1/16 3/32 3/32
CR
0.010 0.010 0.015 0.020 0.015 0.020 0.030 0.030 0.060 0.015 0.020 0.030 0.060 0.015 0.030 0.060 0.015 0.030 0.060
95 71 47 47 35 35 35 24 24 18 18 18 18 12 12 12
79 50 33 33 25 25 25 17 17 12 12 12 12
1/8 1/8 1/8
7,520 5,010 5,010 3,860 3,860 3,860 3,860 2,500 2,500 2,500 1,880 1,880 1,880
7,520 5,010 5,010 3,860 3,860 3,860 3,860 2,500 2,500 2,500 1,880 1,880 1,880
3/16 3/16
1/4 1/4 1/4 1/4 3/8 3/8 3/8 1/2 1/2 1/2
8 8 8 6 6 6
9 9 9
Set the ramping angle to be approximately between 0.3° and 0.5°. 1. Adjust the speed, the feed rate, and the depth of cut to suit your operating conditions, such as the milling shape, machine rigidity, tool holder rigidity, and work holding force. 2. If you are unable to reach the speed and feed rate indicated in the table above, lower the speed and feed rate using the same ratio. 3. If the workpiece gets chipped or if the operation requires a higher level of milling precision, lower the feed rate as necessary. 4. Depending on the shape, if the workpiece chatters, lower the speed and feed rate using the same ratio. 5. To mill graphite, use a dedicated milling machine. To prevent inhalation of dust, use a dust collector and a dust mask when working around graphite. 6. During milling, keep the runout at the tip of the end mill to be less than 0.0004 inches (0.01 mm). 7. When making a rough cut with a 3/16” or greater end mill, you can feed as high as triple the recommended feed rate provided the stepdown is less than the corner radius. 8. If a cut involves the shaping of a corner during side milling, use the corner radius process of the program, or adjust the speed so that it will not cause chattering, and reduce the speed at the corner at the same time (approximately 60%).
osgtool.com
1455
End Mill Technical
Powered by FlippingBook