Display Unit
MAX, MIN, TIR Settings The display unit can hold the maximum (MAX) and minimum (MIN) values, and the run out value (TIR) during measurement.
Zero-setting The display value can be set to 0 (zero) at any position of the spindle.
振れ値=最大値－最小値 MAX Runout value (TIR) = MAX - MIN
0.000
0.000
0.000
Note: Perform the zero-setting beyond 0.2 mm stroke from the rest position. This puts the spindle in the guaranteed accuracy region.
MIN
Presetting Any numeric value can be set on the display unit for starting the count from this value.
Tolerance Setting Tolerance limits can be set in various display units for automatically indicating if a measurement falls within those limits. Open-collector Output An external load, such as a relay or a logic circuit, can be driven from the collector output of an internal transistor which is itself controlled by a Tolerance Judgment result, etc. Digimatic Code A communication protocol for connecting the output of measuring tools with various Mitutoyo data processing units. This allows output connection to a Digimatic Mini Processor DP-1VA LOGGER for performing various statistical calculations and creating histograms, etc. BCD Output A system for outputting data in binary-coded decimal notation. RS-232C Output A serial communication interface in which data can be transmitted bi-directionally under the EIA Standards. For the transmission procedure, refer to the specifications of each measuring instrument. CC-Link An abbreviation of Control & Communication Link, the new open field network developed by Mitsubishi Electric Corporation. It is a high-speed field network that allows for control and communication at the same time.
123.456
1.234
Note: Perform the zero-setting beyond 0.2 mm stroke from the rest position. This puts the spindle in the guaranteed accuracy region.
Direction Changeover The measuring direction of the gage spindle can be set to either plus (+) or minus (-) of count.
＋ / － + / -
基準面 Datum plane
G
RS Link Function Multi-point measurement can be performed by connecting multiple EH counters with RS Link cables. RS Link for EH Counter It is possible to connect a maximum of 10 counter units and handle up to 20 channels of multi-point measurement at a time. IN First counter OUT IN OUT
Last counter
IN
OUT
For this connection use a dedicated RS Link cable 02ADD950 (0.5 m), 936937 (1 m) or 965014 (2 m). (The overall length of RS Link cables permitted for the entire system is up to 10 m.)
RS-232C cable/USB cable
Personal computer
Note: Only the Mitutoyo software
“ SENSORPAK ” can be used when a USB cable is connected.
Gage number
01
02
03
04……
G-19
Powered by FlippingBook