Stands
Dial Gage Stands SERIES 7 • Dial Gage Stands are designed for comparison measurements of size using a dial indicator or Digimatic Indicator. An anvil is provided as standard. • Anvil: ø58 mm serrated anvil, ø58 mm flat anvil, 90 mm square anvil and domed anvil (optional) • Vertical fine adjustment is available with one- touch control thanks to the parallel spring suspension. ø58
Optional Accessories
101462 : Hardened steel serrated anvil
(standard accessory for 7001-10 )
Unit: mm
φ 32
SR20
Hardened steel
φ 58
ø58
101461 : Hardened steel non-serrated anvil (standard accessory for 7002-10 )
Unit: mm
φ 32
SR20
Hardened steel
φ 58
58
ø58
F
7002-10 (with ø58 mm non-serrated anvil)
101463 : Hardened steel domed anvil* (optional) * Not available for 7007-10 .
SPECIFICATIONS Inch/Metric Order No.
Clamping range on column (mm)
Stem hole
Remarks
7001-10 7002-10
With serrated anvil
Unit: mm
0 to 95
ø8 mm, ø0.375 in
With flat anvil
ø32
Note 1: Perpendicularity of the stem hole to the anvil is better than 0.4 mm/100 mm Note 2: Take note that when mounting high-accuracy Linear Gages (with resolution of 0.1 μm or better) to these stands, accuracy may be affected depending on the perpendicularity of the mounting hole to the top surface of the anvil (cosine effect). Note 3: Compact dial indicators (bezel ø31, ø36) are not suitable for use with these stands.
SR20
Hardened steel
ø58
DIMENSIONS
Unit: mm
ø30
80
Column clamp
Fine adjustment
Stem hole
with Bush: ø8 without Bush: ø0.375 in
Indicator clamp
Anvil Flatness: 1.3 µm
ø58
or better
168
110
7001-10, 7002-10 • Clamping range on column: 0 to 95 mm • Flatness of reference surface: 1.3 μm
F-104
Powered by FlippingBook