TG/DA COLLET CHUCKS
STRAIGHT SHANK TG COLLET CHUCKS COOLANT-THRU Coolant-Thru Thru-tool coolant T.I.R. <.0002 " at collet face
MILLING
DRILLING REAMING TAPPING
Features of Straight Shank Tooling • Straight shank tooling may be used to extend tooling reach for extended length operations • This option is less costly than extended length integral shank tooling • Can be used on machining centers or lathes • When loaded into larger holders, their reduced O.D. permits drilling operations within large holes or whenever tight clearances are encountered
D1
STRAIGHT SHANK Part Number Collet Series
Collet Range
Nut Wrench D L L2 D1
S1507-1000-9.00
100TG 3/64-1" 100TG-SPAN 2.50" 9.00" 6.00" 2.50"
L
TG Collet Chucks come with back-up screw.
L2
D
To use: first insert the collet into the chuck nut by squeezing the collet and pressing its face into the chuck nut’s retaining ring until the collet’s collar is fully seated. Then load the assembly into the chuck, insert a cutting tool, and tighten with the appropriate nut wrench to the recommended tightening torque. To remove: simply squeeze the collet while pulling it from the chuck nut at an angle. Toolholder Assembly Procedure
232
847-367-4800
Powered by FlippingBook