TG/DA COLLET CHUCKS
CAT TG COLLET CHUCKS
T.I.R. <.0002 " at collet face
FEATURES • Perpendicular contact between retention knob and holder • AT3 or better taper
RPM
Speed Up to 20,000 rpm
MILLING
DRILLING REAMING TAPPING
Please note that the maximum RPM listed in our catalog may vary depending on the toolholder shank, weight, balanceability and the G rating.
CAT40
D
Collet Range
Nut Wrench L L2
Max. RPM
Part Number C4007-0750-3.00 C4007-1000-2.75 C4007-1000-3.50 C4007-1000-5.50
Style Collet Series
Stubby Stubby
75TG 3/64-3/4" 75TG-SPAN 3.00" 1.89" 20K 100TG 3/64-1" 100TG-SPAN 2.76" 2.50" 20K
L
Standard 100TG 3/64-1" 100TG-SPAN 3.50" 2.50" 20K Standard 100TG 3/64-1" 100TG-SPAN 5.51" 2.50" 20K
TG Collet Chucks come with back-up screw.
Stubby
D
CAT50
Collet Range
Nut Wrench L
Max. RPM
Part Number C5007-1000-3.50 C5007-1000-5.50
Style Collet Series
D
Standard 100TG 3/64-1" 100TG-SPAN 3.50" 2.50" 20K Standard 100TG 3/64-1" 100TG-SPAN 5.50" 2.50" 20K
L
C5007-1000-7.50 Standard 100TG 3/64-1" 100TG-SPAN 7.50" 2.50" 20K C5007-1000-10.00 Standard 100TG 3/64-1" 100TG-SPAN 10.00" 2.50" 20K
TG Collet Chucks come with back-up screw.
To use: first insert the collet into the chuck nut by squeezing the collet and pressing its face into the chuck nut’s retaining ring until the collet’s collar is fully seated. Then load the assembly into the chuck, insert a cutting tool, and tighten with the appropriate nut wrench to the recommended tightening torque. To remove: simply squeeze the collet while pulling it from the chuck nut at an angle. Toolholder Assembly Procedure
Standard
When removing the back-up screw, TG Collet Chucks have coolant-thru capabilities. No disc, special nut or wrench required! See TG Coolant Collets on pages 233-235.
TG Torque Wrench Page 236
TG Back Up Screw Page 236
TG Collets Pages 233-235
TG Nut Page 236
230
847-367-4800
Powered by FlippingBook